Printer-friendly version

Heavy-duty professional shrub arm DHIS with a flail mower 125 cm. and the rotor type F and with the second telescopic arm is installed on tractors and intended for road-side banks cleaning, ditches and water-course banks, for cutting of the grass, bushes and branches up to 7-8 cm. Standard equipment: three point linkage, cat. II; 170 mm. rear adjustable roller; PTO (1000 rpm); drive shaft; locking tie rods; control cable with 5 levers; piston pumps and motor; double gear box (100 hp.);. While operating, on the flail mower is used: rotor with knives type A or articulated Y knives; reverse rotation; pivoting arm frame with the hydraulic cylinder; direct transmission to the flail rotor; floating system on the first arm and on the mower; flail mower with front chains and rear rubber protections; hydraulic breakaway with the hydraulic valve; oil cooler; rear tail light.Model DHIS 1000 Plus is a specific type of machine, built for the use on the banks of canals and differs from the standard version by the following features: the zipper of rotation has the attack of the first arm in the reduced position. The first arm is bent, as in excavators, monolithic; this feature increases the depth of cut in scrap, in comparison with the standard DHIS arm of the same length, this version achieves a greater distance. A second telescopic arm consists of two parts, is built with the octagonal section, not hexagonal, for best linearity of the telescopic arm and a greater resistance to the non-linear strenghts. It is installed as an axial pump and electronic proportional valve for the compensation of the sections, with a joystick. Optionals: multipurpose knives for grass and bushes up to 3 cm. (for rotor type A); multipurpose "Y" knives for grass, bushes and bushes up to 7 cm. (for rotor type D); heavy hammer for grass and bushes up to 8 cm. (for rotor type G); knives for grass, bushes and rushes up to 6 cm. (for rotor type F).Notes: normally on TPCT mowers is used rotor type F, but it is also possible to use other types of rotors: type D for the mixed vegetation, grass and branches, especially for the water-course banks for cutting of the very thin vegetation or type G with a hammer for a large (thick) vegetation up to 8 cm.

TPCT mowers for cutting of the bushes and branches, of heavy series, are installed to the shrub arms with high-performance hydraulic system only for professional purposes. Maximum working diameter of 7-8 cm. Standard equipment: steel plate, not painted, for mounting of top bracket for excavator; piston motor (47 cc); rotor knives type F, made of solid steel SS355-DOMEX 700 (150x10); transmission belts; frontal opening hood. Notes: the mower is equipped only with the flat iron plate, top bracket on request. The hoses are not included in the price.